Our tech team answers a lot of technical calls and emails each day, and there are a lot of common questions asked and advice given. Many of them are about when and where to use our different coatings and paints. Rust products might be the most confusing as far as […]
Tag: rust converter
Rust Encapsulator FAQ
Should I use the Rust Encapsulator as a sealer after treating rusted areas with Rust Dissolver? Can I, or should I just use a primer? – If you fully remove the rust down to clean bare metal with the Rust Dissolver, applying epoxy primer to the areas would be a good way to seal the metal. Rust Encapsulator can also be used in this case, but it should be used in any situation where all rust was not fully removed.
Rust Converter FAQ
What happens if you sand to bare steel and just use as insurance? – Rust Converter needs the rust to properly work and cure (think of it as the catalyst for the product). Rust Converter is intended for heavier rust. If applied over bare metal, it will not cure properly and can actually cause light flash rust.
Rust Converter vs. Rust Encapsulator
Let’s face it, we all have rust issues to deal with. Some projects are better than others, but it’s hard to find a project car or truck that has no rust at all, even if it comes out of the Arizona desert. Eastwood makes many products for dealing with different […]
How To Remove, Treat, and Prevent Rust
Rust is something we all must deal with at some point in our lives. Whether it’s maintaining your daily driver, restoring a classic, or just around the house, rust is a type of corrosion that never sleeps and is always attacking metal. Below are the common ways to prevent, remove and stop rust in its tracks.
The cure for rusty-tank syndrome
It’s one thing to have to fight rust that is easily accessible, like on floor pans or quarter panels, where it isn’t too hard to get to the problem area. Â Nothing is worse than restoring a vehicle, only to find that the fuel tank you have in it is full […]
How to Replace a Rusty Mustang Rear Quarter Panel
From time to time you may notice that we have an old Mustang that we use to test products on and also do photo shoots for ads with. We figured that there was no better way to test one of our new mig welders, than to do a common task many of […]