In this episode of Eastwood’s Internet Café project, JD addresses the dented and rusty fuel tank. The slide hammer dent puller made easy work of the metal. Once the tank was straight, JD treats it with a tank sealer kit for good measure.
Eastwood Projects
Mark’s Trans Am – Episode 5: Replacing a Rusty Floor With New Sheetmetal
In this episode of the Trans Am project, Mark prepares to install new sheet metal in the floor by cutting out what remains of the original floorboards all the way up to the transmission tunnel. With the new floor in place, he seam seals the edges and applies a coat […]
Project Internet Café – Episode 5: Fabricating a Custom Rear Cowl
In this episode of Eastwood’s Internet Café project, JD fabricates the signature café racer detail, the rear cowl, from scratch using new sheet metal and a slip roller.
Mark’s Trans Am – Episode 4: Replacing Rusty Rocker Panels
In this episode of the Trans Am project, Mark digs into the inner and outer rocker panel replacements using manufactured panels from Firebird Central. There’s a fair amount of measurement involved before he gets into the cutting and fitting>
Project Internet Café – Episode 4: Fabricating a Semi-Custom Seat Pan
In this episode of Eastwood’s Internet Café project, JD gets to work modifying the factory two-person seat to convert it into a classic café monoposto perch. After trimming the original seat pan, he crafts a short extension using a bead roller to get the perfect profile before welding it to […]
Mark’s Trans Am – Episode 3: Fabricating a Body Rotisserie
In this episode of the Trans Am project, Mark fabricates a tip-over jig to use in place of a body rotisserie in his tight home garage. This will give him easy access to the bottomside of the car, allowing him to easily replace the floor panels.
Project Internet Café – Episode 3: Fabricating a Custom Electrical Tray
In this episode of Eastwood’s Internet Café project, JD digs into some metal fabrication to make a custom electric equipment tray for the chassis. He gets the tray roughed in and welded up, then paints it in preparation for later installation.
Mark’s Trans Am – Episode 2: Removing a Lead Seam and Making a Patch Panel
In this episode of the Trans Am project, Mark cuts out the factory lead seams in the B-pillars and fabricates a replacement panel using 18 gauge sheet metal formed on a bench brake and shrinker-stretcher. At the same time, he also fabs a patch for the sunroof drain channels that […]
Project Internet Café – Episode 2: Building a Custom Frame Hoop
In this episode of Eastwood’s Internet Café project, JD fabricates a custom rear frame hoop to replace the factory rear seat support and encounters a common problem that occurs when heat from welding warps the work pieces.