One of the biggest hurdles of converting Project Pile House from “garage art” to an actual running, driving vehicle is putting some wiring into the vehicle. I’m running a carbureted small block Cheverolet V8 (SBC) so there is little to make the truck run and move under its own power, but some wiring is needed to make it street legal.
Project Pile House
Building Custom Mini Wheel Tubs for Pile House
One thing a lot of longterm builds have in common is that the builder or owner tend to change their minds throughout the build. This has definitely been the case with Project Pile House. Over the past two years I’ve changed Pile House from being a “thrown-together” type build to something a bit more thought out and nicer. Even small items like wheel and tire combo have changed and caused me to go back and adjust things as needed.
Custom Bomber Seat Fabrication
To be honest, I picked just about the worst possible project vehicle I could when starting Project Pile House. It didn’t have much going for it, the body was dented and rusty, the drivetrain was seized and trashed, and the interior was equally as dilapidated. My goal is to show what can be done on a budget with some key tools and a little bit of creative thinking.
Building a Fuel Cell Cradle and Feeding Pile House with Fuel
Lately I’ve changed gears on Pile House and I’ve decided to start working on getting Pile House moving under its own power. I decided to order up a plastic fuel cell from Jegs first. Once I began test fitting it at a few different spots on the chassis it was obvious that the only place I could fit it under the bed was behind the rear axle.
How to Install an Aftermarket Shifter on a Chevy V8 and TH350.
When building Project Pile House I’ve pretty much discarded all of the original mechanics and I’ve been building from the ground up. I’ve already installed a SBC (small block Chevy V8) engine and a TH350 automatic transmission in the truck. Next I needed to install a universal shifter that would work with the changes I’ve made and look “right”.
Project Pile House Late Summer Update
Last time I checked in on Project Pile House I had just gotten done welding floor pans in and rebuilding the rotten door jambs. Since then I’ve been really busy and I have been slacking on my updates here. I have been posting regular updates on Instagram if you want to follow along feel free to check the #pilehouse tag or view the pics on your desktop HERE.
Early Summer Project Pile House Update.
With the floor pans made up I decided to move outwards and tackle the rust in the door openings. The truck door sill on the drivers side was rotted away and the front of the door opening/jamb was rotted pretty bad. In fact the lower portion was almost non existent.
Building A Custom Steering Column for Project Pile House
Now that the custom firewall was welded into Pile House I could work on making the truck finally steer from inside the cab. This is one big step to making Pile House an actual vehicle rather than a piece of “garage art”. Pile House (like many hot rod and customs) […]
Welding the custom firewall and making a custom transmission tunnel
In the last update I had finally made the firewall a 3 dimensional part and I could almost see the light at the end of the tunnel for this part of the project. Since then I’ve decided it would be a good time to tackle the first part of the […]